DGSI Slope Indicator
Home Products Downloads Support Contacts Projects News

Quattro Logger FAQ

Question: After I changed batteries, my Quattro Logger stopped recording. What's wrong?

Answer: It is important to disconnect the USB cable before you install or change batteries.

If the USB cable remains connected, the logger expects to communicate with the PC. In this mode, the logger cannot go into low-power sleep mode and draws down the batteries. Also, there may be communications problems when a PC and USB cable are reconnected.

If your logger shows these symptoms, remove and replace the batteries (with the USB cable disconnected). Once batteries are in place, you can freely connect and disconnect the USB cable.


Question: I have an older Quattro Logger. I can't communicate with it since I upgraded to a new version of Windows.

Answer: The USB chip and driver may have to be updated for 64 bit Windows: How to Update

 

 

DGSI Information